Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength
of
the stations
is
too
weak (when tuning in with auto tuning).
Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning
in
AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 24).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
If
there
is
a malfunction, the display shows a
message. You can check the condition
of
the
system by the message. Refer to the following
table to solve the problem.
If
any problem
persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output to the speakers.
The receiver will automatically turn offafter
a few seconds. Check the speaker
connection and turn on the power again.
page
16
See
All memorized settings
To
clear
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
fleferenc.e."secliQns:\'o"
.'
.....
-thlrreceiver'sme·m6'~··
.---.':-{,;.,-.:----.-
:"
..
,.
'~-:;--.:>::-:-:-:-.
RDS does not work.*
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger
FM
station.
The RDS information that you want
does not appear.*
• Contact the radio station and find out
whether they actually provide the service
in question.
If
so, the service may be
temporarily out
of
order.
*Models
of
area
code
CEL,
CEK
only.
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries
in
the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
To Next Page
