Note
This function is only available when [Bluetooth Mode] is set to [Transmitter] and [Bluetooth Codec -
LDAC] is set to [On].
[209] Adjusting Settings Zone Settings
Setting whether or not to display [Zone Controls] on
the home menu (Zone Controls)
You can set whether or not to display [Zone Controls] on the home menu by following the steps
below.
[210] Adjusting Settings
Zone Settings
Setting the volume control for Zone 2 (Zone2 Line Out)
Select [Setup] - [Bluetooth Settings] from the home menu.
1
Select [Wireless Playback Quality].
2
Select the setting you want.
Auto: Sets the transmission data rate for LDAC automatically.
Sound Quality: The highest data rate is used. Sound is sent at a higher quality, but
audio playback may become unstable if the link quality is not sufficient.
Standard: A medium data rate is used. This provides a balance between sound quality
and playback stability.
Connection: Stability is prioritized. The sound quality may be reasonable and the
connection status will most likely be stable. This setting is recommended if the
connection is unstable.
3
Select [Setup] - [Zone Settings] from the home menu.
1
Select [Zone Controls].
2
Select the setting you want.
Show: [Zone Controls] is displayed on the home menu.
Hide: [Zone Controls] is not displayed on the home menu.
3
To Next Page
