Sony TC-366 - Page 50

2. Take-up Reel Table Brake Adjustment
See Fig. 2-4, referring the step numbers to the
same ones in the figure.
@) Brake Pressure Angle Adjustment
Adjust the screw marked with e for 3 to4 mm
(4 to 542") distance shown by © .
Apply lock paint to the screw.
@ Brake Adjustment in the Direction C
Bend the lever to obtain a specified braking
torque.
@) Brake Adjustment in the Direction D
When the reading on the spring scale indicates
the greater value than the specified one, bend
the lever in the direction shown by the arrow.
When the reading indicates the less value, cut
off one turn of the spring end and hook the
spring.
(4) Make sure that the clearance © between the
take-up reel table and the brake is 0.3 to
0.5 mm (144") in the REW mode.
2-3. Tape Slack Check
After the brake adjustment, thread a tape on the
machine as shown in Fig. 2-5. Make sure that the
tape does not slack when changing a mode from the
FF to the STOP and also from the STOP to the
REC.
leaf
spring,
instant
stop
2~3mm (%a~ ")
lever, instant stop
2-4.
@
@
7” tape
5” tape
approx. 10mm (fea)
Fig. 2-5 Tape slack check
Instant Stop Adjustment
See Fig. 2-6.
Make sure that the tension regulator adjustment
has been made.
Adjust the screw @ so that the distance
between the end of the instant stop pull rod
and the instant stop stroke adjusting plate is
4 to 6mm (542 to 1544").
Be sure that the clearance between the pinch
roller and the capstan is more than 1 mm
(344) when pulling the instant stop lever in the
FWD mode, and that the instant stop knob is
not locked when pulling it in the STOP mode.
Adjust the screw so that the clearance
between the tension regulator arm and the
instant stop leaf spring is 2 to 3 mm (54 to 14")
in the STOP mode.
Apply lock paint to the screws.
plate, instant stop stroke adjusting
arm, tension regulator
Fig. 2-6 Instant stop adjustment
me Kony 1.7.9 Con! -7-)