Why is the picture from INPUT A connector colored strange on my Sony VPL-CX75 Projector?
If the picture from the INPUT A connector is colored strangely on your Sony Projector, select “Computer,” “Video GBR” or “Component” correctly according to the input signal in the “Input-A Signal Sel.” setting in the SET SETTING menu.
How to fix incorrect color balance on Sony VPL-CX75?
To correct the color balance on your Sony Projector, first, adjust the picture settings. If the issue persists, check that the “Color System” in the SET SETTING menu matches the color system being input.
Why is there no picture on my Sony VPL-CX75?
If there is no picture on your Sony Projector, verify that all cable connections are correct. Ensure your projector is compatible with DDC2B (Digital Data Channel 2B). If it is, connect the projector to the computer, turn on the projector, and then start the computer. Also, select the correct input source using the INPUT key and press the PIC MUTING key to release picture muting, if activated.
Why is there no sound from my Sony Projector?
If you're not getting any sound from your Sony Projector, first, check all cable connections to ensure they are properly connected. Make sure you are using a no-resistance stereo audio cable. Also, verify that the audio is not muted by pressing the AUDIO MUTING key. Finally, adjust the sound using the VOLUME +/– key on the Remote Commander or adjust “Volume” in the PICTURE SETTING menu.
What to do if the picture is too dark on my Sony Projector?
If the picture on your Sony Projector is too dark, adjust the contrast or brightness in the “Adjust Picture...” menu. If that doesn't help, the lamp may be burnt out or dimming, and you may need to replace it with a new one.
What to do if my Sony VPL-CX75 Projector Remote Commander does not work?
If the Remote Commander for your Sony Projector isn’t working, replace the batteries with new ones. Also, check that the COMMAND ON/OFF switch is set to ON and the PJ/NETWORK selector switch is set to PJ.
What to do if the lens protector cannot open on my Sony VPL-CX75 Projector?
If the lens protector cannot open on your Sony Projector due to an electrical system breakdown, slide the lens protector by hand, and then press the I/1 key to use the projector in case of emergency.
What to do if the control panel keys do not function on my Sony VPL-CX75?
If the control panel keys on your Sony Projector do not function, unlock the control panel keys.
What to do if the image extends beyond the screen on my Sony VPL-CX75?
If the image extends beyond the screen on your Sony Projector, and there are black edges around the image, display the full image on the screen and press the APA key. Then, adjust “Shift” in the INPUT SETTING menu.
What does it mean when the TEMP/FAN indicator lights up on my Sony Projector?
If the TEMP/FAN indicator lights up on your Sony Projector, it means the internal temperature is unusually high. Check to ensure that nothing is blocking the ventilation holes. If you are using the projector at a high altitude, make sure that “High Altitude Mode” in the INSTALL SETTING menu is set to “On.”
General| Brightness | 3000 ANSI lumens |
|---|---|
| Resolution | 1024 x 768 (XGA) |
| Contrast Ratio | 500:1 |
| Display Technology | 3 LCD |
| Lamp Type | UHP |
| Lamp Life | 2000 hours |
| Inputs | Composite, S-Video |
| Projection Size | 30 to 300 inches |
| Output Ports | Mini D-sub 15 pin connector |
| Power Consumption | 300 W |
| Noise Level | 35 dB (High Brightness) / 31 dB (Low Brightness) |
To Next Page
