To Next PageTo Next PageWhat does it mean when LAMP/COVER flashes in red (A repetition rate of 3 flashes) on Sony VPL-VW1100ES?
If your Sony Projector displays 'LAMP/COVER flashes in red. (A repetition rate of 3 flashes)', turn off the power and wait for the lamp to cool, then turn it on again. If the symptom persists, the lamp may be at the end of its service life and needs replacement.
Why does my Sony VPL-VW1100ES power off suddenly?
If your Sony Projector suddenly turns off, verify that “Power Saving” in the Setup menu is set to “Standby.” If it is, you can set “Power Saving” to “Off” to prevent this.
How to fix Sony VPL-VW1100ES when the power is not turned on?
If your Sony Projector is not turning on, it may be because you turned it off and tried to turn it back on too quickly. Wait about 1 minute before attempting to power it on again.
How to fix a Sony Projector picture that is not clear?
If your Sony Projector's picture is not clear, try adjusting the focus. If condensation has accumulated on the lens, leave the unit powered on for about 2 hours to allow the condensation to dissipate.
Why is there no picture on my Sony Projector?
If your Sony Projector displays no picture, ensure that the connecting cable is properly connected to the external equipment. If using HDMI, try using the HDMI 2 connector instead of HDMI 1, and select the correct input source using the INPUT button. Also, check that the computer signal is set to output to an external monitor.
Why do the unit and connected equipment turn On/Off, play back, and operate at the same time on Sony Projector?
If the unit and connected equipment turn On/Off, play back, and operate at the same time on your Sony Projector, “Control for HDMI,” “Device Auto Power Off,” and “PJ Auto Power ON” are likely set to “On.” Set them to “Off.”
How to resolve image retention (image is left on the screen) on Sony VPL-VW1100ES?
If an image is left on the screen of your Sony Projector (image retention), and high contrast non-moving images have been displayed for a long period, turning off the power for a while will eliminate the retained image.
Why the lens shift cannot be adjusted on Sony VPL-VW1100ES?
If the lens shift cannot be adjusted on your Sony Projector, it may be at the limit of its range. Adjust the lens shift within its allowable range of movement.
What does it mean when ON/STANDBY flashes in red (A repetition rate of 5 flashes) on Sony VPL-VW1100ES Projector?
If your Sony Projector shows 'ON/STANDBY flashes in red. (A repetition rate of 5 flashes)', it might indicate that the lens protector is not fully open. Try turning the power off and then on again to see if the lens protector opens completely.
Why is my Sony Projector remote control not working?
If your Sony Projector's remote control isn't working, start by replacing the batteries with new ones, ensuring they are inserted with the correct polarities. If there is a fluorescent lamp nearby, it may interfere with the remote control signal. Also, consider the position of the remote control detector on the unit and make sure that it is not obstructed. You can also set “IR Receiver” to “Front & Rear” on the Installation menu.
General| Resolution | 4096 x 2160 |
|---|---|
| Brightness | 2000 lumens |
| Contrast Ratio | 1, 000, 000:1 |
| Lamp Life | 6000 hours |
| Weight | 34.2 lbs (15.5 kg) |
| Display Technology | SXRD |
| Projection Size | 60" to 300" |
| Lens Shift | Horizontal: +/-31% |
| Inputs | HDMI, RS-232C, IR |
| Lamp Type | Mercury lamp |
