35
4 Press the jog lever to enter the
selected surround mode.
Selecting the sound quality
(6-Band Equalizer)
1 While playing, press SOUND
repeatedly to select “SOUND.”
2 Press SOUND for 2 seconds or more.
3 Slide the jog lever repeatedly to select
the sound mode.
Each time you slide the jog lever, A
and B change as follows:
4 Press the jog lever to enter the
selected sound mode.
To cancel the procedure
Press x for 2 seconds or more.
To cancel the setting
Press SOUND repeatedly until the indication at
B disappears.
To modify and store the sound
You can modify the sound and store the
results in “CUSTOM1” and
“CUSTOM2”.
1 Do steps 1 to 3 of “Selecting the sound
quality (6-Band Equalizer)” (page 35), and
slide the jog lever until “CUSTOM1” or
“CUSTOM2” appears.
2 Press the jog lever.
3 Slide the jog lever repeatedly to select the
frequency.
4 Turn the volume control repeatedly to adjust
the level.
5 Repeat steps 3 and 4 to adjust the level for
each frequency.
6 Press the jog lever to enter the selection.
To cancel the procedure
Press x for 2 seconds or more.
To return to the preceding
setting
Press x.
Note
When you assign “SOUND” settings to
“CUSTOM1” or “CUSTOM2”, the maximum
volume setting will be limited to a certain level
(“VOL 24”) to prevent excessive loudness.
For the recorder operation, see
page 62.
LIVE V-SUR L
CLUB V-SUR C
ARENA V-SUR A
AB
HEAVY SOUND H
POPS SOUND P
JAZZ SOUND J
UNIQUE SOUND U
CUSTOM1 SOUND 1
CUSTOM2 SOUND 2
AB
Frequency (100 Hz)
From the left, you can select 100 Hz,
250 Hz, 630 Hz, 1.6kHz, 4 kHz, or 10 kHz
Level (+6 dB)
You can select from among seven levels.
–6 dB, –3 dB, 0 dB, +3 dB, +6 dB
To Next Page
Loading...
