50
5 Turn the jog dial until the number of
the desired last track appears in the
display, and then press the jog dial to
enter the selection.
This selects the last track of the new
group and the group can be labeled.
6 Label a group (see “Labeling
recorded groups” (page 50)).
To cancel the procedure
Press x for 2 seconds or more.
To return the preceding
setting
Press x.
Notes
• In step 4, the first track must be either the first
track of an existing group or a track that does
not belong to a group.
• When selecting the last track in step 5, make
sure the track comes after the one selected in
step 4. The last track must be either the last
track of an existing group or a track that does
not belong to a group.
For the remote control operation, see
page 67.
Releasing a group setting
1 Select a group you want to release
and check the contents (see “Playing
a track in group play” (page 47)).
2 Press x.
3 Press the jog dial.
4 Turn the dial until “EDIT” appears in
the display, and then press the jog
dial.
5 Turn the jog dial until “ : Release”
appears in the display, and press the
jog dial.
“Release?” and “PushENTER”
appear in the display.
6 Press the jog dial to release a group.
The group setting of the selected
group is released.
To cancel the operation
Press x for 2 seconds or more.
To return the setting one level
before
Press x.
For the remote control operation, see
page 67.
Labeling recorded groups
You can label a group while the recorder
is recording or playing a track in the
group. You can also label a group while a
track in the group is selected and the
recorder is stopped.
1 Do the procedure of “Labeling”
(page 40) and select “ : Name” in
step 4, and then do steps 5 to 8.
For the remote control operation, see
page 66.
Jog dial
x
To Next Page
Loading...
