38
Connecting to a stereo
system (LINE OUT)
You can listen to the playback sound from
connected component. Connect the i/
LINE OUT jack of the recorder to the
LINE IN jacks of an amplifier or a tape
player with a line cable.
When connecting a line cable to the i/
LINE OUT jack of the recorder, be sure to
set the “AUDIO OUT” parameter for the
i/LINE OUT jack.
1 Press the jog dial.
2 Turn the jog dial until “USEFUL”
appears in the display, and then press
the jog dial.
3 Turn the dial until “AUDIO OUT”
appears in the display, and then press
the jog dial.
4 Turn the jog dial until “LINE OUT”
appears in the display, and then press
the jog dial to enter the selection.
Notes
• If the “AUDIO OUT” parameter for the i/
LINE OUT jack is set to “LINE OUT”, VOL
+ or –, Virtual Surround, or 6-Band Equalizer
will not function.
• The “AUDIO OUT” parameter for the
i/
LINE OUT jack cannot be set to “LINE OUT”
when the remote control is connected.
• When you connect the headphones/earphones
directly to the recorder, set the “AUDIO
OUT” parameter for the
i/LINE OUT jack to
“HeadPhone” in step 4.
To LINE IN
2 phono plugsStereo mini-plug
R
(red)
Line cable
To i/LINE OUT
Jog dial
Stereo system,
etc.
L
(white)
To Next Page
Loading...
