Adjusting treble or bass
(Digital Sound Preset)
You can adjust the treble and bass to suit
your taste. The ployer can store two sets
of treble-bass adjustments, which can
then be selected later during playback.
MENU
[HT/I_||, I_1_1,
IHH, I/CANCEL
Selecting the sound quality
Factory settings
Factory settings of the digital sound preset
are as follows:
• "SOUNDI': bass +I, treble _0
• "SOUND2": bass +3, treble _0
1 While playing, press MENU.
2 Press _ or _ repeatedly until
"SOUND" appears in the display, and
press ENT/I_II.
3 Press 1"<41or _ repeatedly to
select "SOUND 1", "SOUND2", or
"OFF" in the display, and then press
ENT/I_U to enter the selection.
Selecting "OFF" turns off the digital
sound preset function.
Adjusting the sound quality
You can change the preset sound quality.
To change the preset sound quality, select
"SOUNDI" or "SOUND2", the one you
want to change, in advance.
1 While playing, press MEN U.
2 Press _ or _ repeatedly until
"SOUND" oppears in the display, and
then press ENT/D,'-II.
3
4
5
Press _ or _ repeatedly until
"SET" appears in the display, and
then press ENT/D,'-II.
Press _ or _ repeatedly until
"SOUND1" or "SOUND2" 3ppears
in the display, and then press ENT/
I_11.
The display shows the currently
"BASS" sound setting.
Press _ or _ repeatedly to
adjust the sound level.
Shows "SOUND1" or
"SOUND2" is selected
The soundcan be adjustedin 8 steps.
(-4, -3, ...-+0, ...+2, +3)
6
7
Press ENT/II_I I.
"BASS" is set and the display
changes to "TRE" (ireNe) setting
mode.
Press _ or _ repeatedly to
adjust the sound level, ond then press
ENT/mD_II to enter the selection.
"TRE" (treble) is set.
The sound settings are saved and the
playback display appears again.
19
To Next Page
Loading...
