Connecting the Net MD to your computer
Atler 1he software installation is completed, com_ect the Net iVIDto your computer.
Refer to the operating instructions of the Net MD as well.
I Make sure the remailaing power of the dry battery is sufficient.
Note
Disconnect the dedicated USB cable before replacing 1he dry battery.
2 Insert a recordable disc into the Net MD.
3 Make the power source and the dedicated USB cable connections with the Net
MD and the computer.
Tothe USB
Tothe USBjack/ connectin( terminal
dedicatedjack
Net MD _ __,_ Computer
devices*
Dedicated
USBcab e
* If a cradle is supplied with your Net MD, conneo the dedicated USB cable to the
USB cradle and place the Net MD onto the USB cradle.
4 Check the connections.
When the connections have been properly
made, "PC÷÷MD"* appears in 1he display of
the Net MD.
*Depending on the device, "Net MD" may be
displayed.
Notes
• When tlsthg the Nel MD connected to your compuler, make sure m run the recorder with a new @
batlery. We do not assu_ the results should the_ be a mis-operation, check-out failure, or destruction
of atldio data caused by insuft]cient battery powe_
• Place the recorder on a stable surface so that the dedicated USB cable does ]lot become detached.
39
To Next Page
Loading...
