12
Recording from a
microphone
Connect a stereo microphone ECM-909A,
ECM-MS907, ECM-717, etc., (not
supplied) to the MIC (PLUGINPOWER)
jack.
1 Select the input level with MIC SENS
(on the bottom of the recorder)
Usually, set it to HIGH. When you
record loud sound such as a
concert, set it to LOW.
2 Insert a recordable MD
recording.
Slide REC to the right whil
its button.
“REC” lights up and recording starts.
For details, see “Recording an
right away! ” (page 6
Note
To record from a microphone, you must first
disconnect any digital
the recorder will not switch
tone
input.
MODE
P
REC
Recording in monaural
for double the normal
recording time of an
MD
For longer recordings, choose to record in
monaural sound. The recording time
becomes double the normal.
1 While pressing P, slide REC to the
right.
The recorder stands by for recording.
2 Press MODE.
”Mono REC” appears in the display,
and the recorder switches to
monaural recording.
Press MODE again to record in stereo
sound.
3 Press P again to start recording.
4 Play the sound source.
To stop recording, press p.
The recorder switches back to stereo
recording when you record the next time.
Notes
•If you record in monaural sound from a
stereo source, the sounds from left and
right will be mixed.
•You cannot record in monaural, if SYNCRO
REC is slid to ON.
•The MDs recorded in monaural sound can
be played back only with an MD player/
recorder that has the monaural playing
function.
MIC SENS
to MIC
(PLUG IN POWER)
Stereo microphone
To Next Page
Loading...
