Various ways of recording
15
Setting the clock to
stamp the recorded
time
To stamp the date and
when you record, you firs
clock. When you use the recorder
first time or
charge the built-in
after setting the
1 Connect the power source.
Use the supplied AC power adaptor
2 Press CLOCKSETat the bottom of
the recorder.
Use a pointed object.
The digits of th
3 Enter the current year by pressing
= or + .
To change the digits rap
pressing = or + .
4 Press ( .
The digit of the month flashes.
5 Repeat steps 3 and 4 to enter the
current month, date, hour, and
minute.
When you press ( to set the minute,
the clock starts operating.
If you make a mistake while
setting the clock
Press p, and set the clock again from step
2. You can skip a step by pressing ( .
To display the current time
When the recorder is not operating or
while recording, press DISPLAY
repeatedly until the current time appears
in the display.
To display the time in the 24-
hour system
While setting the clock, press DISPLAY.
To display the time in the 12-hour system,
press DISPLAY again.
Charging the built-in battery for the
clock
After setting the clock, leave the recorder
connected to the AC power for about 2 hours
to charge the built-in battery for the clock.
Once charged, the built-in battery should last
about a month without connecting to any of
the power sources. The recorder will
automatically charge the built-in battery while
connected to AC power, dry batteries or a
rechargeable battery.
=
+
(
CLOCK SET
(on the bottom)
DATE
AM
To Next Page
Loading...
