1. Press SELECT ← or → to select the year, and then press ENTER.
2. Repeat step 1 to set the month, day and time.
To go back to the previous item
Press BACK.
To cancel the clock setting
Press MENU again.
Note
If you do not press any button for about 1 minute while setting the clock, the clock setting mode will be canceled.
Time Format
12H/24H: Select the clock display mode, 12-hour clock or 24-hour clock.
Date Format
The date display mode can be selected from “DD-MM-YYYY,” “DD MMM YYYY” (MMM is JAN, FEB, etc.), “MM-DD-
YYYY,” or “YYYY-MM-DD.”
Beep
Select “On” or “Off.”
About the battery as a backup power source
This unit contains a CR2032 battery as a backup power source to keep the clock and the alarm operating during a
power failure. (No Power No Problem system*)
* No Power No Problem™ is a trademark of Sony Corporation.
Notes on the alarm in the event of a power interruption
In the event of a power interruption, the alarm functions work until the battery is fully discharged. But certain functions
may be affected as follows:
The display will disappear.
If the alarm sound is set to “RADIO,” the
buzzer will sound.
If a power interruption occurs while the
alarm is sounding, the buzzer will sound.
If ALARM RESET/OFF is not pressed, the
alarm will sound for about 5 minutes.
If “Battery Icon” appears on the display, the alarm will not sound in the event of a power interruption. Replace
the battery if “Battery Icon” appears.
The snooze function will not work.
During a power interruption, the alarm will sound only once at the set time.
When to replace the battery
When the battery is discharged, “Battery Icon” appears on the display.
If a power interruption occurs while the battery is discharged, the current time and alarm will be erased.
To Next Page
Loading...
