To
use the unit safely,
see
"Installation and
Connections" (page
6)
for details.
The
nameplate indicating operating voltage, etc.,
is
located on the
bottom
of
the chassis.
Warning
FOR THE CUSTOMERS IN THE USA. NOT
APPLICABLE IN
CANADA,
INCLUDING IN THE
PROVINCE OF QUEBEC.
POUR
LES
CLIENTS
AUX
ETATS-UNIS.
NON
APPLICABLE AU
CANADA,
Y COMPRIS LA
PROVINCE
DE
QUEBEC.
This equipment has been tested and found to
comply with the limits for a
Class
B digital device,
pursuant to Part
15
of
the
FCC
Rules.
These limits are designed
to
provide reasonable
protection against harmful interference
in
a
residential installation. This equipment
generates, uses, and
can
radiate radio frequency
energy and,
if
not installed and used in
accordance with the instructions, may cause
harmful interference
to
radio communications.
However, there
is
no guarantee
that
interference
will not occur in a particular installation.
If
this
equipment does cause harmful interference to
radio or television reception, which
can
be
determined by turning the equipment
off
and
on, the user
is
encouraged to try to correct the
interference by one or more
of
the following
measures:
-Reorient
or relocate the receiving antenna.
-Increase
the separation between the
equipment and receiver.
-Connect
the equipment into
an
outlet on a
circuit different from that to which the receiver
is
connected.
-Consult
the dealer or
an
experienced radio/TV
technician for help.
You
are cautioned
that
any changes or
modifications
not
expressly approved in this
manual could void your authority to operate this
equipment.
2GB
This device complies with Part
15
of
the
FCC
Rules
and Industry Canada's licence-exempt
RSSs.
Operation
is
subject
to
the following
two
conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference,
including interference
that
may cause undesired
operation
of
the device.
This transmitter must not be co-located or operated
in conjunction with any other antenna or
transmitter.
Under Industry Canada regulations, this radio
transmitter may only operate using
an
antenna
of
a
type and maximum (or lesser) gain approved for
the transmitter by Industry Canada.
To
reduce
potential radio interference to other users, the
antenna type and its gain should be
so
chosen
that
the equivalent isotropically radiated power (e.i.r.p.)
is
not more than
that
necessary for successful
communication.
This equipment complies with
FCC/IC
radiation
exposure limits set forth for
an
uncontrolled
environment and meets the
FCC
radio frequency
(RF)
Exposure Guidelines and
RSS-102
of
the
IC
radio frequency
(RF)
Exposure rules. This
equipment has very
low
levels
of
RF
energy
that
is
deemed to comply
without
maximum permissive
exposure evaluation
(MPE).
To Next Page
Loading...
Need help?
General
