Sony XM-GS6DSP User Manual

Mass:
Approx. 2.6 kg
(5
lb
12
oz)
not
incl.
accessories
Package
contents:
Main
unit
(1)
Mounting
screws (4)
High
level
input
cord
(1)
RCA
input
cord
(1)
Speaker
output
cord
{1)
Protection
cap
(1)
Your dealer may
not
handle some
of
the above
listed accessories.
Please ask
the
dealer
for
detailed
information.
Design and specifications are subject
to
change
without
notice.
The Bluetooth® word mark and logos are registered
trademarks
owned
by
the
Bluetooth
SIG,
Inc. and
any use
of
such marks by Sony
Corporation
is
under
license.
Other
trademarks and trade names are
those
of
their
respective owners.
iPhone, iPod,
and
iPod touch are trademarks
of
Apple
Inc.,
registered in the
U.S.
and other
countries.
Google, Google
Play
and Android are trademarks
of
Google
LLC.
Troubleshooting
The
following
checklist will assist in
the
correction
of
most
problems which you may encounter
with
your unit. Before going
through
the
checklist below,
refer
to
the
connection and operating procedures.
The
POWER/PROTECTOR
indicator does not
light
up.
~
The fuse
is
blown.
- Replace the fuse
with
a new one.
~The
ground (earth) wire
is
not
securely
connected.
-Fasten
the
ground (earth) wire securely
to
a
metal
point
of
the
car.
~The
voltage
going
into the remote
input
(REM)
terminal
is
too
low.
- Turn on the car audio unit
if
it
is
not
turned on.
-
Use
a relay
if
the
system employs
too
many
amplifiers.
~
Check the battery voltage
(10.5
V-
16
V).
The POWER/PROTECTOR
indicator flashes
quickly.
~Turn
off
the
power
switch. The speaker outputs
have shorted.
- Rectify
the
cause
of
the
short.
~
Turn
off
the
power
switch. Make sure the speaker
cord and ground (earth) wire are securely
connected.
The POWER/PROTECTOR
indicator flashes
slowly
(once
every
second).
~
The thermal protector has activated, and the
speaker
outputs
will
be decreased.
- Make sure
the
impedance
of
connected
speakers
is
appropriate.
The unit becomes
abnormally
hot.
~The
unit
heats up abnormally.
-
Use
speakers
with
suitable impedance:
2
Q-
8
Q
(stereo), 4
Q-
8
Q
(when used
as
a
bridging amplifier).
~
Make sure
to
place
the
unit
in a well
ventilated
location.
Alternator
noise
is
heard.
~
The
power
connecting wires are installed
too
close
to
the
RCA
pin cords.
- Keep
the
wires away from the cords.
~The
ground (earth) wire
is
not
securely
connected.
-Fasten
the
ground (earth) wire securely
to
a
metal
point
of
the
car.
~
Negative speaker wires are touching the car
chassis.
- Keep
the
wires away from the car chassis.
21GB

Sony XM-GS6DSP Specifications

General

Brand	Sony
Model	XM-GS6DSP
Category	Amplifier
Language	English