1-5-3. Extension Board EX-1296
Procedure
1. Remove the board to be inspected or adjusted.
Note
When a blank panel is attached to the slot of the board to be inspected or adjusted, detach the blank panel.
2. Insert extension board EX-1296 into the slot from which the board was removed referring to the following
figure.
3. Insert the board removed in step 3 into the rail of the EX-1296 extension board, and securely connect the connectors
of both boards.
Connectors
Inspect or adjust board
XVS-8000-C/XVS-8000
1-14
To Next Page
Loading...
