Help Guide
Interchangeable Lens Digital Camera
ZV-E1
Starting tracking with touch operations (Touch Tracking)
You can use touch operations to select a subject you want to track in the still image shooting mode and movie recording
mode.
Configure the settings as follows from MENU →
(Setup) → [Touch Operation] in advance:
[Touch Operation]: [On]
[Shooting Screen] → [Shooting Screen]: [On]
Hint
To cancel tracking, touch
(Tracking release) icon or press the center of the control wheel.
If you set [Touch Func. in Shooting] to [TouchTracking+AE], the brightness will be set according to the subject you touched. This
will also allow you to fine-tune the brightness by sliding the brightness adjustment bar that appears after touching.
Note
[Touch Tracking] is unavailable in the following situations:
When [
Focus Mode] is set to [Manual Focus] in still image shooting mode.
When using Smart Zoom, Clear Image Zoom, or Digital Zoom in the still image shooting mode
If the focus mode is switched to [Manual Focus] while [Touch Func. in Shooting] is set to [Touch Tracking] in still image shooting
mode, the setting value for [Touch Func. in Shooting] will be changed to [Touch Focus].
Related Topic
Touch Operation
Shooting Screen
5-048-827-11(1) Copyright 2023 Sony Corporation
MENU →
(Setup) → [Touch Operation] → [Shooting Screen] → [Touch Func. in Shooting] → [Touch
Tracking].
1
Touch the subject that you want to track on the monitor.
Tracking will start.
2
To Next Page
Loading...
