When you use an AC adaptor, use one with a rated output of 1.5 A or higher.
Use a nearby wall outlet (wall socket) when using the AC Adaptor/Battery Charger. If any malfunction occurs, disconnect the plug
from the wall outlet (wall socket) immediately to disconnect from the power source. If you use the product with a charge lamp,
note that the product is not disconnected from the power source even when the lamp turns off.
If you turn on the camera, power will be supplied from the wall outlet (wall socket) and you will be able to operate the camera.
However, the battery pack will not be charged.
If the product is connected to a laptop computer that is not connected to a power source, the laptop battery level decreases. Do
not leave the product connected to a laptop computer for an extended period of time.
Do not turn on/off or restart the computer, or wake the computer from sleep mode when a USB connection has been established
between the computer and the camera. Doing so may cause a malfunction. Before turning on/off or restarting the computer, or
waking the computer from sleep mode, disconnect the camera from the computer.
Charging cannot be guaranteed with a custom-built computer, modified computer, or a computer connected through a USB hub.
The camera may not operate correctly when other USB devices are used at the same time.
We recommend using a USB-PD device that is compatible with an output of 9V/3A or 9V/2A.
Before charging, be sure to also read “Notes on the battery pack and charging the battery.”
Related Topic
Inserting/removing the battery pack
Notes on the battery pack and charging the battery
5-048-827-11(1) Copyright 2023 Sony Corporation
To Next Page
Loading...
