Help Guide
Interchangeable Lens Digital Camera
ZV-E10
Power Setting Option
You can perform camera power settings.
Menu item details
Power Save Start Time:
Sets time intervals to automatically switch to the power-save mode when you are not performing operations to prevent
wearing down the battery pack.
Power Save by Monitor:
Sets whether or not to enable power-save linkage when the monitor is opened or closed facing inward.
Auto Power OFF Temp.:
Sets the temperature of the camera at which the camera turns off automatically during shooting. When it is set to [High],
you can continue shooting even when the temperature of the camera gets hotter than normal.
Setting the power-save start time
Off/30 Min/5 Min/2 Min/1 Min/10 Sec
Note
Turn off the camera when you do not plan to use it for a long time.
The power-save function is deactivated in the following situations:
During [
USB Streaming]
While power is being supplied via USB
While playing back slideshows
While recording movies
While connected to a computer or TV
When [Bluetooth Rmt Ctrl] is set to [On]
Setting the power-save linkage with the monitor
Both Linked:
Enables power-save linkage with the monitor. The camera returns from power saving mode when the monitor is opened,
and enters power saving mode when the monitor is closed facing inward.
Open: Return:
The camera returns from power saving mode when the monitor is opened.
Close: Power Save:
The camera enters power saving mode when the monitor is closed facing inward.
Does Not Link:
Disables power-save linkage with the monitor.
MENU →
(Setup) → [Power Setting Option] → select an item that you want to set.
1
MENU →
(Setup) → [Power Setting Option] → [Power Save Start Time] → desired setting.1.
MENU →
(Setup) → [Power Setting Option] → [Power Save by Monitor] → desired setting.1.
To Next Page
Loading...
