5
* Your AP should recover from this state after a maximum of 5 minutes.
4. LED Status
Off
Off AP is off or reboot started
Green
Solid Normal operation
Flashing AP is booting & connecting to wireless controller
*
Red
Solid Error, no wireless controller found. AP will reboot (if not yet claimed
by a controller). Check network connection if error persists.
If reset button pressed: AP preparing configuration reset
Flashing slowly Configuration reset in progress
*
Flashing fast Firmware update in progress
*
Note: Do not disconnect from power
5. Access Point Reboot & Reset
Reboot with current image and configuration
1. Press reset button
2. Release reset button
3. AP reboots (LED will go off, then will turn to solid green)
Quick Start Guide APX 120
To Next Page
Loading...
