Sophos APX Series Quick Start Guide

1
For more information about your device, scan the QR code or visit
www.sophos.com/get-started-ap
Quick Start Guide APX Series Access Points
* Please check https://community.sophos.com/kb/en-us/124444#Sophos Access Points for availablity
1. Before Deploying
Congratulations on the purchase of your Sophos APX Series access point. This Quick
Start Guide provides you with instructions to connect the access point and do the initial
configuration.
Before you begin, please make sure that you have access to one of the following
products which include the Sophos wireless controller needed to manage your Sophos
access point:
Ì Sophos Wireless (Sophos Central managed)
Ì Sophos SG UTM
*
Ì Sophos XG Firewall
*
Please ensure you have a valid license for one of the above products.
To power and connect your access point you will need to have either a PoE injector
(available as an accessory from your Sophos partner) or a PoE switch plus an RJ45
Ethernet cable.

Sophos APX Series Specifications

General

Wi-Fi Standards	802.11a/b/g/n/ac
Frequency Bands	2.4 GHz, 5 GHz
MIMO	2x2
Ethernet Ports	1 or more Gigabit Ethernet ports
Power over Ethernet (PoE)	802.3at PoE+
Security	WPA3, WPA2, WPA, WEP, 802.1X, AES, TKIP
Management	Sophos Central
Mounting	Ceiling, wall
Operating Temperature	0°C to 40°C (32°F to 104°F)
Model	APX 320, APX 320X, APX 530, APX 740, APX 940, APX 530X