Soren CS 800 - General Safety Information; Safety First

INSTRUCTION AND SERVICE PARTS MANUAL - FREEZER CS 800, s/n F0176-00 - ALFRED & CO
D1
3. SAFETY
3.1. GENERAL SAFETY INFORMATION
The following information provides specific information on hazardous
conditions which are inherent in the Continuous Ice Cream Freezer.
The SOREN Continuous Ice Cream Freezer is a mechanical freezing machine
which by the very nature of its design creates certain unavoidable hazards.
Safe operation requires the application of sound and prudent operating,
maintenance and servicing procedures under the direction of properly trained
supervisors.
Our objective in providing instructions and warnings is to identify each area of
potential hazards and its level of severity and to guide each worker for safe
operation, service and maintenance procedures.
SOREN equipment is designed to provide minimum operator access to
hazardous areas while providing adequate access for service by trained
personnel. Hazardous areas are provided with guards. Various types of
fasteners may be used for the guards depending on how frequently routine
access is required. Regardless of the type of fastener used, the mere
existence of a guard should alert the worker to the presence of a hazard.
Never operate or test run the equipment with a guard removed, unless under
the supervision of properly trained and authorized personnel. Then use
extreme caution to avoid the hazard.
DEFINITIONS:
DANGER !
An immediate hazard with a possibility of severe personal injury or death
if instructions, including recommented precautions, are not followed.
WARNING !
Hazard or unsafe practices which could result in severe personal injury or
death if instructions, including recommented precautions, are not
followed.
CAUTION !
Possible hazard or unsafe practices which could resultyn minor injury or
damage to product or property if instructions including recommented
precautions, are not followed.
3.2. SAFETY FIRST
SOREN equipment is designed and manufactured with due consideration and
care for generally accepted safety standards. However, like any mechanical