Soren CS 800 - First Cleaning

INSTRUCTION AND SERVICE PARTS MANUAL - FREEZER CS 800, s/n F0176-00 - ALFRED & CO
M1
1010. CLEANING AND SANITIZING
DANGER !
The use of water around electronic equipment enclosures creates a
hazard of electric shock which could cause severe injury or loss of life.
Turn off the electric power supply and lock out before using any water for
cleaning or rinsing around the electrical enclosures. Be certain the doors
on all electric enclosures are closed and fasteners tightened. Never spray
water directly into any electric controls or enclosures.
.
CAUTION !
The presence of any water inside electrical control enclosures, may ruin
the controls. Be certain the doors on all electric enclosures are closed and
fasteners tightened. Never spray water directly onto any electric controls
or enclosures.
DANGER !
Direct contact with cleaning/sanitizing solutions may cause chemical
burns. Equip all personnel performing cleaning/sanitizing operation with
protective clothing (including eye protection).
CAUTION !
Do not use any acid type cleaner to clean the inner cylinder: acid attacks
the chrome inner cylinder lining.
Buyer is liable for the chemical solutions used for cleaning/sanitizing. In particular
these chemical products must be compatible with the inner cylinder lining.
Chemical cleaning supplier should give directions about the right products, their
recommended concentrations, temperature and exposure times.
10.1. FIRST CLEANING
Carefully clean all product contact surfaces prior to use, to eliminate all
possible foreign material which may have accumulated during manufacture,
shipment and installation. In addition this gives plant personnel an opportunity
to become familiar with the freezer.
• Use a detergent solution.
• Disassemble all of the product contact areas of the freezer, including:
- freezer cylinder front door;
- dasher assembly;