To Next PageTo Next Page
Need help?Do you have a question about the Sorensen DLM300-13E and is the answer not in the manual?
Details warranty terms, conditions, and procedures for product returns and repairs.
Overview of DLM-E Series power supplies, their capabilities, and intended applications.
Explanation of Constant Voltage, Constant Current modes and automatic crossover behavior.
Highlights key features including power ratings, input options, efficiency, and AC power factor.
Detailed electrical specifications for the 3 kW models, covering voltage, current, and regulation.
Detailed electrical specifications for the 4 kW models, covering voltage, current, and regulation.
Presents additional specifications including AC input requirements, efficiency, and operating environment.
Provides physical dimensions, weight, and output connector details for DLM-E models.
Guide to recommendations and procedures for inspecting, testing, and installing the power supply.
Critical safety information for personnel and equipment during installation and operation.
Procedure for performing a physical check of the unit and its components after unpacking.
Description of all front panel controls, buttons, switches, and LED indicators.
Details the connectors, terminals, and switches located on the rear panel of the unit.
Overview of basic operation, covering local programming, modes, and remote sensing.
Explains power supply operation using Local Programming in Constant Voltage and Current modes.
Details the operating modes and how the supply automatically switches between them.
Procedure for adjusting output voltage and current limit using front panel controls.
Explains how to use remote sensing to compensate for voltage losses in load lines.
Introduces advanced features like remote programming, OVP, shutdown, and multiple supply configurations.
Details switch, connector, and DIP switch functions for remote operations and monitoring.
Guides on setting output voltage and current limit using external analog input sources.
Explains how to set and use the Over Voltage Protection (OVP) circuit for load safety.
Describes activating the shutdown function via front panel or remote signals for output control.
Details how to remotely monitor status indicators and readback signals using the J3 connector.
Covers configuring supplies for series, parallel, and split supply operations to achieve higher voltage or current.
Explains how to disable front panel controls for secure remote programming operation.
Information on periodic maintenance, cleaning, and calibration requirements for the unit.
Provides a diagnostic guide for identifying and resolving common operational issues.
Details potentiometer locations and adjustment procedures for output voltage, current, and OVP calibration.
Contact information and instructions for ordering replacement parts from Sorensen.
Lists the types, ratings, and sizes of fuses used in the DLM-E Series power supplies.
General| Brand | Sorensen |
|---|---|
| Model | DLM300-13E |
| Category | Power Supply |
| Language | English |
