Need help?Do you have a question about the Sorensen XT Series and is the answer not in the manual?
General| Input Frequency | 47-63 Hz |
|---|---|
| Output Voltage Range | 0-600V |
| Interface | RS232, USB, GPIB |
| Cooling | Forced air |
| Operating Temperature | 0 to 50 °C |
| Humidity | 5% to 95% non-condensing |
| Power Factor | >0.9 |
| Protections | OVP, OCP, OTP |
Presents detailed electrical characteristics and ratings for XT Series models.
Details tests to verify basic functionality of the power supply.
Explains how remote sensing compensates for voltage drops in power leads.
Describes the two basic operating modes: Constant Voltage and Constant Current.
Details how the power supply operates in Constant Voltage mode.
Details how the power supply operates in Constant Current mode.
Describes the procedure for setting the maximum output current limit.
Steps to operate the power supply in Constant Current mode.
Explains the automatic switching between voltage and current modes.
Covers connecting multiple supplies in series, parallel, or split configurations.
Explains the internal power circuit on the A2 assembly.
Describes the pass element section for different model types.
Explains the operation of the voltage control circuit.
Provides general troubleshooting advice and techniques.
Describes calibration procedures for assemblies and parameters.
Details calibration procedures for the Front Panel Assembly (A1).
Details calibration procedures for the Power Assembly (A2).
To Next Page