EasyManua.ls Logo

Sorma BSS-134 - Page 13

Sorma BSS-134
81 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
MACHINE SAFETY
BSS-134
CHAP.- 4
- Never stand on the machine.
- Never leave the machine or installation unguarded while it is running.
- Notify the maintenance staff of any operational anomaly on special devices.
- Avoid working on the machine while wearing objects which may cause accidents (watch, tie, bra-
celet, ring etc.).
- Never work on the machine with long hair loose.
- Button up the sleeves of your work clothes carefully.
- Work on the machine respecting technical rules, act to guarantee the safety of the operators.
- Examine the safety stickers and plates applied to the machine carefully, and comply with the in-
structions they provide.
- All works on under voltage parts must be carried out only by authorised staff.
Before starting work, disconnect the electric current using the appropriate main switch located on
the front of the electric control board and remove the pressure from the pneumatic circuit.
- Do not perform seals of any kind in the electric connections of the electric circuits.
- Do not intervene for any reason on moving parts, even if to unblock an entanglement.
- Maintain the ground of the surrounding area of the machine constantly clean from encumbrances
and water.
- Always wear protection glasses, ear protectors and every other personal protection device in the
areas requiring it.
- Always pay particular attention to the precaution, warning and danger signals placed on the machine.
- Apply and ensure the safety rules are always complied with, in case any doubt should arise, consult
this manual again before acting.
- It is forbidden to inhibit the safety devices.
- It is forbidden to inspect the machine during functioning.
- It is forbidden to sit and/or rest on the personal protection devices.
- It is forbidden to respect on the machine during functioning.
- It is forbidden to sit and/or rest on the machine components.
- It is forbidden to amend parts of the machine.
- It is forbidden to apply further devices to the machine.
- Clean the machine components, the panels and the controls using soft and dry cloths.
- For the research or removal of any fault or inconvenience, use all precautions, described in the
manual, suitable for preventing any damage to persons and/or things and/or animals.