11
MACHINE SAFETY
BSS-134
CHAP.- 4
4.1 Safety warnings
The warnings listed below must be carefully read to become fundamental part of the daily practice in
the running and maintenance of the machine, in order to prevent any type of injury to persons and/
or damages to things.
Do not try to function the machine until the functioning has not been fully under-
stood.
In case of doubts, despite having carefully and fully read this manual, contact the
Clients After-Sales Technical Assistance Service of Sorma S.p.A.
Ensure that all prescriptions relating to safety are aware to all staff involved in the use, cleaning and
maintenance of the machine.
Before starting the machine, the operator must verify the eventual presence of
visual defects on the same and on the safety devices.
In this case, immediately notify to the Clients After-Sales Technical Assistance
Service of Sorma S.p.A. every evident anomaly.
-The manufacturer declines any responsibility for damage to people or things, due to non-compliance
with safety regulations.
- Any attempt to dismantle, modify or tamper with any part of the machine will invalidate the warranty,
and Sorma S.p.A. will be held harmless for any damage to people or things due to such abuse.
- The assistant operator must possess all the psychological and physical requirements and capacities
needed for using the machine.
- Concentrate properly, and take every precaution, before using the machine in any way.
- The working area in front of the machine must always be kept clean and free for immediate access
to the main switchboard under emergency conditions.
- Effect the working cycle start-up sequence only in the way laid down here.
- Never open machine doors or protections without specifi c authorisation and training, and never
before having cut off the air and power supply.
- Never use the machine with casings or protections removed.
- Never use the machine with protections disabled or damaged.
- Never put your hands, body parts or anything else, near or inside moving or live parts of the ma-
chine, or in the electric cabinet.
- Never modify programme parameters in order to obtain a performance different from the kind pro-
vided for and programmed during design and testing.
- Always work under suitable conditions of lighting in order to always have a clear view of the opera-
ting and working area.
To Next Page
Loading...