*8
START-UP AND STOP
BSS-134
CHAP.- 7
7.5 Stopping the machine in the event of an injury or failure
It is absolutely necessary to:
1) disconnect the power supply by using the designated main switch in the front of the
electric control board (setting it to [OFF]) and block the switch with a padlock (see fi g.2
chap.7) whose key is held only by qualifi ed personnel (trained and authorised to conduct
maintenance work on the machine).
2) bleed pressure from the pneumatic circuit by closing the slide valve [A] (see fi g.2 chap.7)
and bleeding the residue air in the machine's circuit.
Fig.2 chap.7
A
To Next Page
Loading...