2
GENERAL INFORMATIONS
BSS-134
CHAP.- 1
All the information on the plate must be legible at all times.
Use the identifi cation data in all correspondence with the manufacturer (e.g. when
requesting spare parts, information, assistance).
1.4 Warnings
The warnings, with instructions on risk-identifi cation procedures, are highlighted by the symbols
shown below. Do not underestimate their importance: machine damage and operator injury are real
possibilities.
DANGER = This symbol informs that the non-compliance with the indications can
cause damages to the equipment and can jeopardise the safety of persons. Care-
fully read the note at the side.
PROHIBITION = This symbol indicates the prohibition of carrying out certain mano-
euvres and/or operations with the machine that, in certain conditions, can threaten
the safety of the operator and of the same machine. Carefully read the note at the
side.
Examine the on-machine safety plaques carefully and observe the relevant information.
1.5 Machine identifi cation
The identifi cation plate [A] contains the following information:
- MACHINE MODEL
- SERIAL NUMBER
- YEAR OF MANUFACTURE
To Next Page
Loading...