79
RE-INSTALLATION AND DEMOLITION
BSS-134
CHAP.- 11
11.1 Re-installation
The activities described in this paragraph must be carried out only by qualifi ed staff, and
precisely:
- SORMA S.p.A. technician with the help of local labour;
- trained technician who has attended specialisation and training courses and with
experience with regard to installation, start-up and maintenance of the machine, and is
aware of the accident-prevention Standards.
To dismantle the machine, in case of sale, re-installation or storage at the client’s premises, proceed
according to the following general dismantling procedure:
a) depending on the dimensions of the transport mean available and the number of parts in which to
subdivide the machine, decide how to dismantle it and in which parts;
b) position the mobile parts of the machine in the most favourable position for transport;
c) in correspondence of the joining points, number all parts that will be separated, so as to make
future re-assembly easier;
d) disconnect the electric power supply and the pneumatic supply;
e) disconnect all electric cables as follows:
1. disconnect the cables in the electric control board;
2. remove them from the conduits to the unit they are connected to;
f) mechanically dismantle the machine subdividing it in the established parts;
g) mechanically block or strap all parts that may move during transport;
h) replace the vent cap with a blind cap in the gearmotors that might fi nd themselves in a position
such to leak oil.
For new placement and connection refer to the relative paragraphs in this manual.
11.2 Storage
In case of prolonged storage, leave the machine covered from rain and wind and, possibly, in a dry
place.
Protect, in particular, electric parts, electric control boards and control panels and all parts sensitive
to humidity and low temperatures.
To Next Page
Loading...