Need help?Do you have a question about the Soundcore Liberty 4 and is the answer not in the manual?
Insert earbuds into the case and ensure ports are dry before charging.
Connect via USB-C or wireless charger; fully charge before first use.
Earbuds power on and enter pairing mode when the case is opened.
Connect by selecting the device from your phone's Bluetooth list.
Hold the charging case button for 3 seconds to initiate manual pairing.
Earbuds pause playback when removed and resume when worn.
Wearing either earbud automatically answers an incoming call.
Reset to resolve pairing issues with each other or other devices.
Hold the case button for 10 seconds with the case open for reset.
General| Driver Size | 11mm |
|---|---|
| Frequency Response | 20 Hz - 40 kHz |
| Bluetooth Version | 5.3 |
| Charging Time (Case) | 2 hours |
| Water Resistance | IPX4 |
| Impedance | 16 ohms |
| Charging Port | USB-C |
| Wireless Charging | Yes |
| Transparency Mode | Yes |
| Multipoint Pairing | Yes |
| Codecs | SBC, AAC, LDAC |
| Voice Assistant | Yes |
| Touch Controls | Yes |
| Battery Life (Earbuds) | 9 hours |
| Battery Life (with Case) | 28 hours |
| Charging Time (Earbuds) | 1.5 hours |
| Noise Cancellation | Yes |
| Bluetooth Range | 10 meters |
| Microphone | 6 microphones |
To Next Page