DAB112 / English Instruction Manual
3
SETTING THE VOLUME
➢ Press “VOL +/-“ button until the volume level appears in the display. Volume range: 0 to 32
SETTING THE LANGUAGE
To set the device to your language …
➢ Press and hold “MENU/INFO” button to open system menu, select “system” and confirm
with “SCAN/SELECT”.
➢ Press “ ” until “Language” is shown and confirm with “SCAN/SELECT”.
➢ Press until your desired language is shown and “SCAN/SELECT”.
Note:
If you don't press any button for a number of seconds then the display will revert back to the
previously selected mode.
The settings that are not confirmed are not saved.
➢ To quit the menu, briefly press the “MENU/INFO” button.
DAB
SELECTING THE OPERATING MODE
Briefly press the “ /MODE” button repeatedly to switch between the DAB, FM radio and BT
(Bluetooth
®
) modes.
TUNING IN DAB+ MODE
Switching to DAB mode will automatically retrieve the station last selected.
1. Briefly press “ ”. The full list of stations will open.
2. Use “ ” to select the desired station and confirm with “SCAN/SELECT”.
Note:
➢ You will also find the complete list of stations in the system menu under “Station List”. Here
you can also start a full manual “Scan”.
➢ You can select specific frequencies/frequency blocks under “Manual Tune” in the system
menu.
The signal strength of the chosen frequency block will be shown as bars on the display.
There are no setting options. Press “MENU/INFO” button to quit the system menu.
➢ Not all stations are on the air at all times; many that were once on the air have since
disappeared; or you have received stations in another region that you can no longer receive
in your new location: To clean up the station list, you can remove these stations in the
system menu with “Prune Invalid”.
➢ Press “MENU/INFO” repeatedly to view different information about the station, the music
etc., depending on the station.
To Next Page
Loading...
