SOUNDMASTER DAB112 - Bluetooth Features; Establishing Bluetooth Connection; Playing Music via Bluetooth; Disconnecting Bluetooth Devices

DAB112 / English Instruction Manual
5
BLUETOOTH
®
In the Bluetooth
®
mode you can connect your Bluetooth
®
-enabled mobile device and play saved
music files via the radio.
Note: Always refer to the instruction manual for your mobile device. The device cannot connect
to a Bluetooth
®
speaker or headphones
ESTABLISHING A CONNECTION
➢ Switch on the Bluetooth
®
function on your mobile device.
1. Briefly press the “ /MODE” button to select the BT mode.
2. The display shows Disconnected flash while the device is searching for a Bluetooth
®
signal. The BT LED indicator will light up in blue.
3. Start the device scan on your mobile device.
4. Select “DAB112OR” on your mobile device and connect the devices as usual.
PLAYING MUSIC
The radio can play music in all conventional file formats supported by your mobile device.
➢ First start playback on your mobile device.
You can also perform these functions directly on the DAB radio:
➢ Press “SCAN/SELECT” to start and pause playback.
➢ To return to the start of the track or to skip to the previous track, press once or twice.
➢ Skip to the next track with .
➢ Press the VOL +/- button to adjust the volume.
Note:
If the volume is too low, adjust it on your mobile device.
DISCONNECTING THE DEVICE
There can only be one device connected to the radio via Bluetooth
®
at any time. If you would
like to connect another device, you must first disconnect the current device. Proceed as follows:
➢ Unpair the devices on your mobile device.
➢ The devices will also unpair if you move them outside the Bluetooth
®
range.
Note: If you switch off the radio, it will automatically connect with the Bluetooth
®
« device again
once it is switched back on, provided it is close by and switched on and the BT function is
activated.
USING HEADPHONES
Listening to music at a high volume on a regular basis can lead to hearing
damage. Set the volume to a low setting before starting to play music through
the radio. Then you can set the volume higher if you want.
1. Lower the volume.
2. Use a 3.5mm jack plug to connect an earphone or headphone to the headphone port.
3. If necessary, increase the volume. This mutes playback via the speaker.
Note: Earphone with line-control is not compatible to this radio.