If necessary, stick the supplied adhesive tapes on the underside of the frame for better
slip and stability.
POWER SUPPLY
Use only the supplied power adapter!
➢ Ensure that the voltage is the same as that indicated on the AC adapter identification plate.
➢ Connect the supplied AC adapter to a properly installed safety power socket and the plug of
the cable into the DC IN jack at the back side of the unit.
➢ Charge the built-in battery completely before using it for the first time!
BATTERY POWER INDICATOR
While the device is playing in battery mode, press the “INFO/MENU” button repeatedly until the
display show “Battery xx” (xx = Battery level).
When the battery power is low and need to re-fill, the battery icon in the right corner of the
display is flashing and the display show “Battery Low”.
ERP power management
The unit will turn off automatically after about 15 minutes in standby mode if there is no
audio signal. To turn on the unit again press the “ / MODE” button.
BASIC OPERATIONS
POWER ON / OFF (Power supply operation)
Press “ / MODE” to switch the unit on; press and hold “ / MODE” to switch into standby.
POWER ON / OFF (Battery operation)
Press the “ / MODE” button to turn the unit in standby. The display show “Welcome to Digital
Radio” and then the time and date is shown.
In standby, press the “ / MODE” button to turn on the unit.
In on mode, press and hold the “ / MODE” button to turn the unit in standby. The time and date
are shown in the display.
In standby, press and hold the “ / MODE” button to turn the unit in power saving mode.
Note: In standby mode, if you don´t press any button, the unit will automatically turn off into
power saving mode after about 15 seconds.
SELECTING MODES
During playing mode, press the “ / MODE” button repeatedly to switch between the modes.
ADJUSTING VOLUME
To increase or decrease the volume, rotate the “VOL-/VOL+” knob.
To Next Page
Loading...
