SOUNDMASTER DAB970 - DAB Radio Functions; Manual Tuning; Station Presets

DAB970 / English Instruction Manual
7
Some stations are secondary services associated with a Primary channel and only available
at certain times. Any station that has associated secondary services is indicated with a
double chevron pointing to the right. The Secondary radio station stations are always listed
next to their primary station rather than the normal is indicated with a double chevron
pointing left.
Manual tune
As well as the normal method of scanning, you can also manually tune to a particular channel
/frequency. This can be useful for adjusting your antenna to achieve the best possible reception
and scanning a particular channel to update the station list.
1. Press “MENU” button on the unit or remote control.
2. Select “Manual tune” and press “OK” to confirm.
3. Use the “ / ” button on the remote control or rotate the “NAVIGATE” knob on the unit
to display a particular channel/frequency and press the “OK” button on the remote control or
on the unit to tune the selected channel/frequency.
4. The display shows a live indication of the received signal strength on the selected frequency.
5. Adjustments to your antenna will be manifested in the received signal strength displayed.
Note:
The slightly larger rectangle indicates the audio quality threshold - if the signal strength, as
indicated by the solid rectangles, falls below this threshold the audio quality will deteriorate. At
the same time the unit scans for any DAB stations on the selected frequency and updates the
station list with any new stations found. To listen to any stations found, return to the “Now
playing” screen and select the required station from the station list as normal.
Presets
The unit has 40 preset memories for DAB.
Store a station in a preset memory
1. Select the desired station.
2. Press and hold the “ PROGRAM” button on the remote control about 3~5 seconds until the
display shows “ Preset Store”. Presets (1-40) are displayed as either “ Empty” or with the
currently stored station name.
3.
Use the
“ / ”
button on the remote control or rotate the “NAVIGATE” knob on
the unit to choose a preset memory, then press the “OK” on the remote control or on unit to
store the currently playing station. After confirming the preset station is stored, the display
reverts to the “Now playing” screen.
Note:
If a preset memory is already occupied, you can simply replace the old one with the new
one. It is not necessary to delete the old preset station.
Recall a preset station
Press the “PROGRAM” button briefly, the display will show “Preset Recall”. Select one of the
listed preset stations by using the “ / ” buttons on the remote control or rotate the
“NAVIGATE“ button on unit. Then press the “OK” button on the remote control or on the unit to
choose the selected preset station.