MCD4850 / English instruction manual
ENG 3
CONNECTION
1. Connect the power cord (43) to ac outlet and connect the speaker wire to the speaker terminal (40)
located on the rear side of unit.
2.
Switch the Off/On/Radio selector(7) to tuner position, if the power LED indicator (5) light up and sound
is coming out from the speaker, it’s mean the power supply is normal. And now your system is ready to
play the music
.
LISTENING TO RADIO
MANUAL TUNING
1. Select the desire band by the band selector (6).
2. Tune to the required station by turning the tuning knob (21).
3. Adjust volume up/down button (18) to the desire volume level.
FM & FM-STEREO RECEPTION
Set the band selector (8) at “ FM ” position. Programs are received in mono mode. In particular when
stereo signal are weak. It is preferable to receive the program in mono.
Set the band selector (8) at “ FM-ST. ” position for receiving stereo programs. The FM-stereo LED
indicator (4) will light up to show FM stereo program is receiving.
HINTS FOR BEST RECEPTION:-
- AM :
The receiver has a built-in am bar antenna. If AM reception is weak, slightly rotate or
re-positioning of the unit will usually improve the am reception.
-
FM :
The receiver has a built-in FM wire antenna (39) hanging at the rear cabinet. This wire should be
totally unraveled and extended for best reception.
PLAYING COMPACT DISC/MP3 AT
The system equipped with 2 CD player, here below describe the function for
:-
GETTING START
1. Press the CD 1 button (19) to “ /Aux “ mode.
2. Press “Open/Close” button (9) to open the CD door (15).
3. Place a CD with the printed side facing up inside the tray & then close the co door.
4. Focus search is performing, the LCD display (2) will show the total number of tracks .
PLAY / PAUSE MODE
1. If Play/Pause button (10) is pressed during stop mode, the first track will be played .
2. If Play/Pause button (10) is pressed during playback, system go to pause mode and the play
indicator “ “ will start flashing at the LCD display (2). Press again to resume normal playback.
STOP MODE
1. If Stop button (11) is pressed during play or pause mode. Go to stop mode and display total
number of track on the LCD display (2).
SKIP MODE (SKIP UP /SKIP DOWN )
1. During play or pause mode, if Skip Up button (12) is pressed it will go to next track and display the
track no. and then continuous the play or pause mode.
2. During play or pause mode, if Skip Down button (12) is pressed, it will go back to the beginning of
the track, same track no. is display and continuous the play or pause mode.
3. After step 2, press Skip Down button (12) again, it will go to the previous track and continuous the
play or pause mode.
REPEAT PLAY MODE
Press the Rep/Ran button (14) before or during playback, a single track, single folder(for MP3 disc
only) or all the tracks repeat and random playback can be selected as follow
:-
To Next Page
Loading...
