MCD4850 / English instruction manual
ENG 5
CD DISC PROGRAMMING (BY REMOTE CONTROL)
- Up to 32 tracks can be programmed at CD-2 mode.
- After program play and you can delete the programmed track in the order from the last one to the 1
st
one by pressing the “ clear “ button at remote control. This function allow you to re-program the
memory from the middle if necessary.
REMARK:-
- The reaction time of the CD burner is longer than normal CD player due to the complicacy system.
Keep pressing with all difference function within a short time may cause mal-function of the system.
Please re-start the unit if this is happen.
-
the reading and playback time of CD-R(W) disc is various from brand to brand. It depends on the
compatibility of the used disc
.
RECORDING FUNCTION AT CD-2
Apart from the CD playback function, CD-2 can perform the CD recording function either from Phono /
Tape / / Aux mode respectively. All the recording track will be stored at “ Audio-CD “ format:-
Before start, place a CD-R or CD-RW disc in the CD compartment. The disc is able to record only if the
LCD display show “ NO TOC “ indicator.
Remark : CD-R disc can be recorded once only and not support erase or re-record function. The playback
quality of either CD-R(W) disc is various from differences kind of audio CD player device.
IMPORTANT NOTICES:-
- The revolving speed of CD-2 (CD burner) is higher than normal CD mechanism. thus, some
mechanical noise and vibration of unit cabinet may occur during operation. This is not the malfunction
of the system.
- Due to the variety on the quality and the compatibility of CD-R(W) disc from the market. Please
change other brand if you found the used one is not able to record or the performance is not so stable.
A) RECRODING MODE
I) CD RECRODING
i) RECORDING BY MANUAL
1) Press the CD 1/Aux button (19) to “ /Aux “ mode. Place the recorded CD inside
compartment & remain at stop mode.
2) Press “REC “ button (31) and then the CD “ Play/Pause ” button (24) at CD-2 until the play
indicator “ “ show on LCD display (2).
3) After few seconds, the LCD (2) will show the time counter and now the system is start recording
process. Now start the playback of the CD at .
4) After completing of recording, press the “ stop ” button (27) at CD-2 and then stop the playback of
.
ii) RECODING BY PROGRAM
1) Press the CD 1/Aux button (19) to “ /Aux “ mode. Place the recorded CD inside
compartment & remain at stop mode.
2) Select the desire tracks by following “ CD Disc Programming “ procedures.
3) Repeat the same procedures from step 2 to 4 as described on part A-I-i from above (recording by
manual) to complete the recording.
II
) PHONO RECODING
1) Press the Phono button (17) to select “ Phono “ mode. Place the recorded vinyl & get ready for
playback.
2) Press “REC “ button (31) and then the CD “ Play/Pause ” button (24) at CD-2 until the play
indicator “ “ show on LCD display (2).
3) After few seconds, the LCD (2) will show the time counter and now the system is start recording
process. Now start the playback of the vinyl at Phono.
4) After completing of recording, press the “ stop
” button (27) at CD-2 and then stop the playback of
vinyl.
To Next Page
Loading...
