SOUNDMASTER UR800 - Getting Started; Backup System; Standby Button; Vol Button

UR800 / English Instruction Manual
2
GETTING STARTED
Connecting to power
1. Connect the cord of the power adapter to the “DC IN” jack of the radio.
2. Connect the plug of the power adapter to a wall socket.
The radio is powered and in standby mode when you see the display is switched on.
BACKUP SYSTEM
 The radio is equipped with a backup system. It requires 2x 1.5 V AAA batteries. Insert the
batteries into the battery compartment and make sure the positive and negative (+ or -) sides
of the battery are in contact with the corresponding terminals in the battery compartment.
 If a power cut occurs, the radio automatically switches to the battery power supply and
keeps the clock and timer settings.
 When replacing the battery, do not disconnect the power adapter. Otherwise, all clock and
alarm settings will be lost.
TIME SET
1. Under the clock mode, press the “SET” button, the 2 digits for “HOUR” will blinking, and you
can press “UP” or “DOWN” button to adjust the hours
2. Press the “SET” button again, the 2 digits for “MIN” will blinking, and you can press “UP” or
“DOWN” button to adjust the minutes
3. Press the “SET” button the 3
rd
time to set the 24HR or 12HR, the defaulted set is 24HR, and
you can press “UP” or “DOWN” button to set 12HR or 24HR
4. Press the “SET” button the 4
th
time to set the snooze time, such as “05”means snooze 5
minutes and you can press “UP” or “DOWN” button to set your desired snooze time
5. Press the “SET” button the 5
th
time revert to clock mode
MODE/ STANDBY BUTTON
You can press “MODE/ ” button to switch the function from FM/LINE/OFF
You can also press and hold the “MODE/ ” button to switch the unit OFF.
VOL BUTTON
Under FM/LINE mode, press the “VOL” button, “L10” is the defaulted volume level, and you can
press “UP” or “DOWN” button adjust to your desired volume level
Total 15 volume levels