SOUNDMASTER UR800 - Radio Operation; Alarm Function

UR800 / English Instruction Manual
3
RADIO OPERATION
Press the “MODE/ ” button to switch the radio on.
Press “UP” or “DOWN” button to adjust the frequency.
Press and hold the “UP” or “DOWN” button to automatically tune to the next available FM
station.
MEMORY THE STATIONS
Under FM mode, select your desired FM station, then pressing and holding the “MEM” button
for more than 3 seconds, at this time “01”will blinking and you can press “UP” or “DOWN”
button to select the storage station no., then press “MEM” button to confirm this action
You can storage total 20 FM stations
RECALL THE STATIONS
Under FM mode, press “MEM” button to obtain the storage FM stations, and you can press
“MEM” button continual to obtain the stations from “01-20”
ALARM FUNCTION
ALARM SET
1. Switch the unit in the standby mode.
2. Press the “ALARM” button, then enter into ALARM 1 mode, the 2 digits for “HOUR” will
blinking, and you can press “UP” or “DOWN” button to set the hours
3. Press the “ALARM” button again, the 2 digits for “MIN” will blinking, and you can press “UP”
or “DOWN” button to set the minutes
4. Press the “ALARM” button the 3
rd
time into ALARM 1 alarm ring mode, and you can press
“UP” or “DOWN” button to select alarm ON=BUZZER/FM/AUX or turn OFF the alarm
5. Press the “ALARM” button the 4
th
time, then enter into ALARM 2 mode, the 2 digits for
“HOUR” will blinking, and you can press “UP” or “DOWN” button to set the hours
6. Press the “ALARM” button the 5
th
time, the 2 digits for “MIN” will blinking, and you can press
“UP” or “DOWN” button to set the minutes
7. Press the “ALARM” button the 6
th
time into ALARM 2 alarm ring mode, and you can press
“UP” or “DOWN” button to select alarm ON=BUZZER/FM/AUX or turn OFF the alarm
SNOOZE
Under the alarm ring mode, you can press “SNOOZE” button into snooze waiting time
SLEEP
Under FM/LINE mode, pressing and holding the “SLEEP” button for more than 3 seconds, the 2
digits for sleep minutes will blinking, and then you can press sleep button continual to select the
sleep time from “05-15-30-45-60-75-90-00”
Remark: If you already opened the sleep function, you can check the remaining sleep time by
long press the sleep button for the first time