2. Select the desired CHASE button.
3. Press the TAP SYNC/DISPLAY button to switch the LED display to steps.
4. Review each scene/step individually by using the BANK UP/DOWN buttons.
8.4. Edit a Chase
Copy a Bank into A Chase
1. Press and hold the PROGRAM button to enter programming mode.
2. Press the desired CHASE button.
3. Select the BANK to be copied using the BANK UP/DOWN buttons.
4. Press MUSIC/BANK COPY button to prepare copy.
5. Press MIDI/Add button to copy the bank. All LEDs will blink.
Copy A Scene Into A Chase
1. Press and hold the PROGRAM button to enter programming mode.
2. Press the desired CHASE button.
3. Select the BANK to be copied using the BANK UP/DOWN buttons.
4. Press the SCENE button that corresponds to the scene to be copied.
5. Press MIDI/Add button to copy the scene. All LEDs will blink.
Insert A Scene Into A Chase
1. Press and hold PROGRAM button to enter programming mode.
2. Press the desired CHASE button.
3. Press TAP SYNC/DISPLAY to switch the LED display to steps view.
4. Use BANK UP/DOWN buttons to navigate steps and locate the insert point of
the new scene. The display will read the step number (for example: to insert a
scene between Step 05 and 06, navigate using BANK buttons until the display
reads STEP 05).
5. Press MIDI/Add button to prepare the insert and LED display shows “STEP 06”.
6. Use the BANK UP/DOWN button to locate the SCENE.
7. Press the SCENE button that corresponds to the scene to be inserted.
8. Press MIDI/Add button to insert the scene. All LEDs will blink.
17
To Next Page
