To Next Page

To Previous Page

TRANSMITTER PROGRAMMING

ENTERING REMOTE PROGRAM MODE

The system can lean up to 3 different transmitter codes. Each remote to be used MUST be

programmed together during the same sequence. For security, when a new remote is

programmed all previous remote’s are deleted. Please see remote operation chart for

information on using Second Car / Pad Lock Operations.

Press and HOLD the valet switch, siren will chirp ONCE

(If siren does not chirp repeat step 1)

CONTINUE TO HOLD until siren chirps 5 times

Press & Release LOCK button on 1st Remote to be

Programmed for Normal Operation If remote(s) are to be

programmed for "PADLOCK" skip and goto step 6

Press & Release the Trunk Button on Remote to be

Programmed for 2ND CAR OR PADLOCK operation.

Siren will Chirp 1 time to confirm remote has been programmed

(If siren does not chirp press button again)

Siren will Chirp 1 time to confirm remote has been programmed

(If siren does not chirp press button again)

PROGRAMMING REMOTE’S

Cycle the Ignition Key - ON/OFF ON/OFF ON

(Leaving the key ON)

Turn ignition key OFF to exit remote program mode when all

required remote’s have been programmed.

1 chirp confirms program mode entered followed by

5 chirps confirming transmitter program mode

1 -

2 -

3 -

4 -

6 -

5 -

7 -

8 -

REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION

REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION

NOTE: ALL REMOTE’S TO BE USED MUST BE PROGRAMMED IN SEQUENCE

WHILE IN REMOTE PROGRAM MODE, RE-ENTERING REMOTE PROGRAM MODE

WILL ERASE ALL PREVIOUS REMOTE’S

SYSTEM PROGRAMMING - Menu 1

INSTALL MANUAL

TRANSMITTER PROGRAMMING

AL.1

Soundstream AL.1 User Manual

Questions and Answers: