Soundstream AL.1 - Shock Sensor Adjustments; Enter Shock Sensor Adjustment Mode; Adjusting Sensor Sensitivity; Exit Sensor Adjustment Mode

SHOCK SENSOR ADJUSTMENTS
3 CHIRPS
Press and HOLD the Lock and Unlock buttons
Hold both buttons until the siren chirps to confirm the shock
sensor setting. (1-10 chirps)
NOTE- If no buttons are pressed the Shock Sensor Adjustment
Mode will automatically time out after 8 seconds.
Each time the lock button is pressed and released the sensitivity will be
INCREASED by 1 level.
This is confirmed by a series of park light flashes and siren chirps.
1 Flash / Chirp is the least sensitive setting
10 Flashes / Chirps is the most sensitive setting
Each time the unlock button is pressed and released the sensitivity will
be DECREASED by 1 level.
This is confirmed by a series of park light flashes and siren chirps.
1 Flash / Chirp is the least sensitive setting
10 Flashes / Chirps is the most sensitive setting
Hold both buttons until the siren chirps 3 times.
*The system will Arm or Disarm via silent arming prior to
entering adjustment mode.
1 - ENTER SHOCK SENSOR ADJUSTMENT MODE
2 - ADJUSTING SENSOR
3 - EXITING SENSOR ADJUSTMENT MODE
+
+
SYSTEM PROGRAMMING - Menu 1
INSTALL MANUAL
SHOCK SENSOR
AL.1