TN5.950D Wire Connections
TN5.950D Wire Connections End Panel
123
1. Speaker Connection Terminal
Connect speaker(s) with a minimum impedance of 2Ω to the
corresponding (+) & (-) terminals.
2. Fuses
if overloaded. In the event they fail, replace with similar type
and amperage value. Using a higher amperage value may lead
to electrical damage and is not considered covered by the
limited warranty.
3. Power Connection Terminal
GND Connect good quality 8ga. ground wire to the nearest
vehicle chassis ground.Take a moment to properly prepare the
ground location for the best ground.
REM Connect the remote turn-on output of the source unit to
the r
emote terminal.
+12V Connect good quality 8ga. power wire to the vehicle’s
battery. Always protect the vehicle by using a fuse within 18”
from the battery.
Connect a subwoofer with a minimum impedance of 2 to
the corresponding (SUB-) & (SUB+) terminals.
To Next Page
Loading...
