SA260 Nemesis Delay User’s Guide 8
applicable) will be on the tip contact of the plug, and the Neuro App data will be on the ring contact.
This allows audio and Neuro data to flow on the same cable.
MIDI Thru
This is a standard 5-pin DIN connector that echoes MIDI messages from the MIDI INPUT jack and sends
them to other devices. The Nemesis does not generate any of its own MIDI data, but it will copy and
output any data it receives.
Power and Control Connections
DC 9V (Power)
Connect to the included 9 Volt DC power supply. If you would like to use a 3
rd
-party supply, the
power supply must be regulated at 9 Volts DC (direct current), able to source at least 200 mA
(milliamps) of current, and the plug should have a tip-negative, barrel-positive polarity.
USB
Connect to your computer (Mac or Windows) to the Nemesis’ USB port (denoted by the icon)
using a standard mini USB cable. The Nemesis is a class compliant USB device, meaning that it does
not require any custom drivers. For more information about the Nemesis’s USB capabilities, refer to
the USB section of the User’s Guide.
Control Input
The 3.5 mm CONTROL INPUT port connects to external control devices such as the Source Audio Dual
Expression Pedal, Reflex Universal Expression Pedal, Neuro Hub, and Hot Hand Motion Controller.
For more information, refer to the Expression Pedal Input, Hot Hand Input, and Neuro Hub sections
of the User’s Guide.
To Next Page
Loading...
