SA163 Reflex User’s Guide 18
Shape Selection
The Shape Button selects which shape will be used for the currently selected output. The
corresponding LED will indicate which shape is active. If no LED is lit, the output is disabled.
Random Sample-and-Hold LFO
User-Defined Shape (Reserved for future use)
If all LEDs are turned off and the LED display briefly displays the word OFF, this means
that the selected output is disabled.
Parameter Editing
The Parameter Button selects which parameter to edit using the control knob. There are a total of 5
parameters: Min, Max, Depth, Type, and Chan. The analog expression outputs and the sensor output
only utilize the first 3 parameters: Min, Max, and Depth. The digital (MIDI) outputs utilize all 5
parameters. When the Parameter button is pressed, a corresponding LED will light up to show which
parameter is currently being edited.
Use the Control Knob to edit the currently selected parameter.
Min Parameter
When an output is configured with a taper shape, the min parameter defines the minimum value it
can output. For more information, refer to Taper Min Parameter.
When an output is configured with an LFO shape, the min parameter defines the minimum frequency
of the LFO. For more information, refer to LFO Min Parameter.
Max Parameter
When an output is configured with a taper shape, the max parameter defines the maximum value it
can output. For more information, refer to Taper Max Parameter.
When an output is configured with an LFO shape, the max parameter defines the maximum
frequency of the LFO. For more information, refer to LFO Max Parameter.
Depth Parameter
When an output is configured with a taper shape, the depth parameter can invert the taper shape.
For more information, refer to Taper Depth Parameter.
When an output is configured with an LFO shape, the depth parameter controls the amplitude of the
LFO. For more information, refer to LFO Depth Parameter.
To Next Page
Loading...
