Sourcetronic ST500 Series - Chapter 5 Function parameter; 5-1-10.F8 Group - Fault and protection

Chapter 5 Function parameter
43
Chapter 5
246.
F7.41
Cooling fan control
0: Fan running only when running
1: Fan always running
0
☆
247.
F7.42
Timing function selection
0: Invalid 1: Valid
0
★
248.
F7.43
Timing run time selection
0: F7.44 setting
1: AI1
2: AI2
3: Panel potentiometer Analog input
range corresponds to F7.44
0
★
249.
F7.44
Timing run time
0.0Min to 6500.0Min
0.0Min
★
250.
F7.45
Current running reaches
the set time.
0.0Min to 6500.0Min
0.0Min
★
251.
F7.46
Awakens frequency
dormancy frequency (F7.48) to
maximum frequency (F0.19)
0.00Hz
☆
252.
F7.47
Awakens delay time
0.0s to 6500.0s
0.0s
☆
253.
F7.48
Dormancy frequency
0.00Hz to awakens frequency (F7.46)
0.00Hz
☆
254.
F7.49
Dormancy delay time
0.0s to 6500.0s
0.0s
☆
255.
F7.50
AI1 input voltage
protection lower limit
0.00V to F7.51
3.10V
☆
256.
F7.51
AI1 input voltage
protection upper limit
F7.50 to 10.00V
6.80V
☆
257.
F7.52~
F7.53
Reserve
258.
F7.54
Jog mode setting3
Units digit:
0: forward
1: reverse
2: determine the direction from the
main terminal
Tens digit:
0: restore to the previous state after
jogging
1: stop running after jogging
Hundreds digit:
0: return to the previous deceleration
time after jogging
1: keep the deceleration time the
same after jogging
002
☆
5-1-10.F8 Group - Fault and protection
No.
Code
Parameter name
Setting range
Factory
setting
Chang
e
259.
F8.00
Overcurrent stall gain
0 to 100
20
☆
260.
F8.01
Overcurrent stall
protection current
100% to 200%
-
☆