Pag.9
When you must drive, do not drink.
Pay attention to traffic when operating near or crossing roadways.
Reduce speed when transporting mounted implement to avoid bouncing and loss of steer-
ing control.
Pay attention when you turn curves or you go up and down on hills with the implement.
Be sure that at least 25% of the tractor’s weight is on the front wheels to maintain safe
steering. Drive at a low speed.
NEVER allow riders on implement or tractor. Falling off can kill.
Be a safe and courteous driver.
Maintenance safety
Good maintenance is your responsibility. Poor maintenance is an invitation to trouble.
For maintenance follow these common practises:
- keep service area clean;
- use adequate illumination for the job;
- be sure tools and electrical outlets are properly grounded;
- make sure there is plenty of ventilation.
Before making maintenance on this machine, drive to a level area, disengage the PTO,
lower the machine, turn off the engine, set the brakes and remove the ignition key.
Keep all persons away from operator control area while performing maintenance.
ALWAYS use personal protection devices.
Periodically tighten all bolts, nuts and screws.
The implement manufacturers assumes no liability if replacement parts other than the
original factory parts are used.
After servicing, be sure that all safety shields are re-installed properly.
Be sure that all safety decals are installed, clean and in good condition.
If the machine is modified from the original design, no responsibility for the manufacturer
can be claimed.
To Next Page
Loading...