Sovema EM-3 - Every 200 Working Hours: Belt Replacement; Every 300 Working Hours: Gearbox Oil

Every 100 working hours
• Check the superficial state of the wheels. These are made of full rubber and are subject to
worn after a while.
Every 200 working hours
• Replace the belts. Actually this substitution is necessary when belts present cuts or evident
worn signs. To proceed with replacement follow these instructions:
a) Before replacement check condition of the pulleys and bearings;
b) Clean the pulleys from residual material of the old belts;
c) Be sure pulleys rotate liberally and firmly;
d) Tension belts correctly (see chapter on Trouble Shooting).
Every 300 working hours
• Completely replace gearbox oil, proceeding as explained before. Use oil SAE 80 W 90
API GL4.
TOXICOLOGICAL INFORMATION ABOUT
LUBRICANTS
Pag.27
TYPES OF DANGER
PROTECTIVE EQUIP-
MENT
PRIMARY INTERVEN-
TION
SKIN
Possible irritation after
prolonged contact
Gloves and/or lotion bar-
rier
Wash with soap & water
EYES
Possible irritation on con-
tact
Protective goggles
Rinse thoroughly w/ run-
ning water
INHALATION
Possible irritation after
prolonged exposure
Maintain an oil mist level
of 5mg/m3 between TLV-
TWA limits
Expose to fresh air and
call medical assistance
immediately
INGESTION
Such possibility not con-
sidered
DO NOT provoke vomit-
ing; call medical assis-
tance immediately