Unloading defects
If the operator of the machine finds difficulty on unloading the product just cut, stop and fol-
low these instructions:
- Verify the presence of wet grass and mud under the frame.
In fact it is possible that grass and mud get stuck in the lower part of the frame, interfering
with the unloading function.
- Verify that grass or other solid object are not stuck around the knives.
Before checking the machine to find the possible cause of mal-
functioning, be sure the tractor’s PTO is disconnected, tractor’s
engine turned off, brakes on, key ignition off the command
board, and the machine completely lowered to the ground.
Pag.21
To Next Page
Loading...