RETRIEVING I/M READINESS STATUS
I/M Readiness function is used to check the operations of the Emission System. It is an
excellent function to use prior to having a vehicle inspected for emissions compliance. Some
latest vehicles may support two types of I/M Readiness tests:
A. Since DTCs Cleared - indicates status of the monitors since the DTCs are erased.
B. This Drive Cycle - indicates status of monitors since the beginning of the current drive
cycle.
An I/M Readiness Status result of "NO" does not necessarily indicate that the vehicle being
tested will fail an I/M inspection. One or more such monitors may be allowed to be "Not
Ready" to pass the emissions inspection.
1. Use SCROLL button to select I/M Readiness from
Diagnostic Menu and press ENTER/EXIT.
If more than one module is detected, you
will be prompted to select a module before
test.
Use SCROLL button to select a module and press ENTER/EXIT button.
2. Wait a few seconds to validate the
PID MAP.
To Next Page
Loading...